| No. | Note text |
| * | The remaining thread dimension is a theoretical technical value that indicates how much remaining thread the chassis still has after the lowest, TÜV-tested setting. The remaining thread may only be used on public roads if the TÜV has approved this through an individual inspection. For show and shine area, this can be used off public roads if this is possible due to the design of the respective vehicle, i.e. the remaining thread is not automatically the area of use. It should be noted that deeper settings outside the TÜV-tested range can lead to greater wear and damage to other vehicle parts. The TÜV-tested range should therefore always be adhered to. |
| 1 | Excluding models with 4 wheel steering. |
| 2 | Excluding four wheel drive models. |
| 3 | Not for vehicles with electronic damper control. |
| 4 | Excluding models with automatic level control, or automatic level system can be adjusted in accordance. |
| 5 | Complete suspension kits are excluding models with automatic level control, please use our springset. |
| 6 | The front indicator lights on these vehicles must be relocated or replaced. These can be acquired from the manufacturer under order number 46226698. |
| 7 | Front axle height adjustable, rear axle consists of lowered sports springs and sports dampers. |
| 8 | In combination with original wheels and tyres, wheelspacers might be necessary. |
| 9 | Only for cars with a clamp diameter of 55 mm on the front axle. |
| 10 | Only for cars with a clamp diameter of 50 mm on the front axle. |
| 11 | Rear shock absorbers with eye-mounting. |
| 12 | Rear shock absorbers with fork-mounting. |
| 13 | We recommend a special anti roll bar kit (part no. ZB50-016/ ZB50-017 for models with a drive shaft diameter of min. 50mm. This is for improving the clearance of the right hand side drive shaft. Because of car specific differences a clearance is not always given. |
| 14 | Not for cars from 2004 onwards with standard 16“wheels. |
| 15 | The lowering rate will be reduced for models with original sports suspension. |
| 16 | On the front axle struts you need to measure the whole distance of the lower mounting drills. This distance has to be 72mm. |
| 17 | Please replace the anti-sway bar kit on max. TÜV tested lowering. This is for enough clearance of the right drive shaft. Anti-sway bar kit for cars without Xenon headlights: part no. ZB50-016 Anti-sway bar kit for cars with Xenon headlights: part no. ZB50-017. |
| 18 | Please use different top mounts for models with a year of construction earlier than 6/92 (BMW part no.: 31336764947; disk 31331116983; nut 31331110196). |
| 19 | On the front axle struts you need to measure the whole distance of the lower mounting drills. This distance has to be 58mm. |
| 20 | Rear axle shock absorbers are not atjustalbe for dumping. Sport shock absorbers with a harder dumping characteristic will be supplied. |
| 21 | Only for 4 wheel drive models (4x4, 4motion, Quattro etc.). |
| 22 | Only for vehicles where the rear shock absorber is attached at the bottom with an M14 bolt. |
| 23 | or 8cyl. engine are required from the automobile manufacturer: for the front: (BMW Part No.: To My. 09/97 = 31 35 2 298 910, Till My. 09/97 = 31 35 2 298 911), for the rear: (BMW Part No.: dome bearing 33 521 091 710 + washer 33 521 092 986). |
| 24 | For the rear axle sport shock absorbers will be supplied, the factory air spring will maintain. The lowering of the vehicle needs to be done according to the instructions. |
| 25 | At vehicles equipped with electronic damping DCC, the electronic damping control needs to be deactivated. |
| 26 | At vehicles equipped with audi magnetic ride, the electronic damping control needs to be deactivated. |
| 27 | At vehicles equipped with electronic damping, the electronic damping control needs to be deactivated. |
| 28 | not for vehicles with Xenon headlights. |
| 29 | Additional attachments are required from the automobile manufacturer (for the Fiat Bravo/Brava only available for vehicles with original sport suspension). Fiat Part No.: support bearings 00046469709 + strut insulator 00046448102 |
| 30 | Vehicles with a two-part leaf spring on the rear axle have to be equipped with a one-piece leaf spring. (up to mod.2015; VW part no. for leaf spring spring 2K5511151N; from mod.2015-; VW part no. for leaf spring spring 2K5511151AA) |
| 61 | Only for vehicles where the rear shock absorber is attached at the bottom with an M10 bolt otherwise use article no. 11560012. |
